Peak-system-technik PCAN-DONGLE IPEH-002019 Bedienungsanleitung PDF herunterladen (Seite 7)

PCAN-Dongle (ISO) – User Manual

First Test

After turning on the PC the red LED at the PCAN-Dongle must be

permanently on. This indicates that the power supply for the PCAN-

Dongle is correct.

Attention! Don't remove PCAN-Dongle from the PC while

powered on (red LED on PCAN-Dongle is lit). Electronic parts of

the PCAN-Dongle or the PC's parallel interface may be harmed.

2.2 Connecting a HS-CAN

A CAN is connected to the 9-pin Sub-D port on the PCAN-Dongle.

The pin assignment corresponds to the CiA recommendation DS

102-1.

Figure 1: Pin assignment HS-CAN

(view onto male connector of the PCAN-Dongle)

2.3 5-Volt Supply at the CAN Connector

A 5-Volt supply can optionally be routed to pin 1 and/or pin 9 of the

CAN connector (PCAN-Dongle ISO: pin 1 only) by setting solder

bridges on the PCAN-Dongle PCB (Dongle case opened). Thus

devices with low power consumption (external transceivers or

optocouplers, for example) can be directly supplied via the CAN

connector.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Keine Kommentare

Peak-system-technik PCAN-DONGLE IPEH-002019 Bedienungsanleitung Seite 7